admin
M600 5-2.A
Aseptic valve manifold with butt weld connections, machined from a single block.
Zero deadleg depending on installation position. Other options on request.
| Pipe connections:
Valve seats: Construction: Use as a diverter valve Other options on request |
5
2 A |
M600 5-4.B
Aseptic valve manifold with butt weld connections, machined from a single block.
Zero deadleg depending on installation position. Other options on request.
| Pipe connections:
Valve seats: Construction: Interconnected ports Other options on request |
M600 3-3.B
Aseptic valve manifold with butt weld connections, machined from a single block.
Zero deadleg depending on installation position. Other options on request.
| Pipe connections:
Valve seats: Construction: Interconnected ports Other options on request |
M600 3-3.A
Aseptic valve manifold with butt weld connections, machined from a single block.
Zero deadleg depending on installation position. Other options on request.
| Pipe connections:
Valve seats: Construction: Valve seats centrally connected Other options on request |
3
3 A |
M600 3-2.C
Aseptic valve manifold with butt weld connections, machined from a single block.
Zero deadleg depending on installation position. Other options on request.
| Pipe connections:
Valve seats: Construction: All pipe connections vertical Other options on request |
M600 3-2.B
Aseptic valve manifold with butt weld connections, machined from a single block.
Zero deadleg depending on installation position. Other options on request.
| Pipe connections:
Valve seats: Construction: Main pipe vertical Other options on request |
3
2 |
M600 3-2.A
Aseptic valve manifold with butt weld connections, machined from a single block.
Zero deadleg depending on installation position. Other options on request.
| Pipe connections:
Valve seats: Construction: Main pipe horizontal Other options on request |
3
2 A |
Manifold Designs
M600 valve manifold designs, developed and produced according to customer requirements.
Multiport Valves M600 Series
|
|
The fabrication of complex piping systems has always been done through complicated welding methods. The valves, fittings and pipe components which were used required a large amount of space and mounting effort to produce. Dead spaces were often unavoidable, but they had to be accepted as standard practice because of lack of alternatives.
With the introduction of the new GEMÜ type M600, machined from one solid piece, we can now wave goodbye to the previous problems associated with older manifolds. All valve weirs, connective geometry and cross connections are now integrated into one unit.
The Benefits:
- Made to customer specification
- Compact construction
- No dead spaces
- Self draining
- Fittings, welding and time-consuming maintenance are no longer necessary
- Shorter validation times
Type 695 1/2" – 2"
|